5-62
a) Setting of long range management
Select 1.LR BROADCAST, Long range broadcast can be set.
AIS transmits own ship’s position or navigation status by long range broadcasting (using satellite etc.)
The channels are specified in item 2.and item3.
The AIS will respond, in cases where a coast radio station requests own ship's information.
Select from ON or OFF with ▲ key or ▼ key.
ON ････････ Transmit the response by the setting
channel (set at item 2. and item3.) .
OFF ･･･････ Not transmit the response.
But requested by LR port,
Output the response through LR port.
Press ENT key to decide after selection
Set the channel to transmit for long range response.
Input the channel number one digit at a time.
(Refer to “5.2.5 numerical input”)
Factory default settings are 2075ch and 2076ch.
Caution：Normally, AIS is operated by regulated channels.
Ship’s administrators must be responsible for any change.
b) Setting of long range response
Select 4.LONG-RANGE, Long range response can be set. Long range transmission operates in cases
where the AIS is connected to equipment that supports long range transmission.
In this menu the response type shown in paragraph 5.3.2.5 "Confirmation of long range message"
refers.
AUTO: Respond automatically
MANUAL: Respond by manual
c) Save the setting
Save the setting of item from 1 to 4.
Select [SET], save the setting and switch to SET UP
menu.
Select [EXIT], discard the setting and switch to the SET
UP menu.
LONG-RANGE
1.LR BROADCAST:OFF
2.CH A:2075
3.CH B:2076
4.LONG-RANGE:AUTO
To Next Page
Loading...