JRC JHS-183 - 5.3.3.2 Communication Test

5-41
5.3.3.2. Communication Test
Select 2.COMMUNICATION TEST at “MAINTENANCE” menu screen (refer to “5.3.3 MAINTENANCE”) ,
“COMMUNICATION TEST” screen is displayed.
The address MMSI can be set automatically from nearby ships, and then perform the communication
test with others by response request.
To switch to “MAINTENANCE” menu screen, press CLR key.
In order to transmit communication confirmation contents, select [TX] and then press ENT key.
After transmitted, its responded result is displayed.
Responded --------------------- ACK: OK
Not responded ---------------- ACK: NG
Select [OK] in this Popup, and then press ENT key, and the screen is switched to
“COMMUNICATION TEST” screen.
Also “RESULT:“ on the bottom line in “COMMUNICATION TEST” screen is displayed the response
result after transmission.
Responded --------------------- RESULT: OK
Not responded -----------------RESULT: NG
Select [TX]
COMMUNICATION TEST
NO
W
TRANSMITTING. .
COMMUNICATION TEST
ACK :OK
[
OK
]
COMMUNICATION TEST
[
TX
]
[
CANCEL
]
DESTINATION:
MMSI:987654321
RESULT:--
Communication test
screen