JRC JHS-183 - Page 84

5-58
a) Input name
・ Select desirable number to change or register and Press ENT key and then the cursor move to
SHIP NAME.
・ Press ENT key at SHIP NAME, SHIP NAME input screen is displayed.
・ Refer to “5.2.4 character input method“ to input.
b) MMSI input
・ After the inputting the name, select MMSI and press ENT key, and then MMSI can be inputted.
・ MMSI can be inputted one digit at a time. (refer to 5.2.5 Numerical Input)
・ After inputting the last digit, press ENT key and MMSI setting is finished. The screen move to the
GROUP SHIP screen.
c) Save and Clear
This item is as follows
SAVE ･･････････ Save the input after editing
CLEAR ･････････ Erase the register which is selected or edited and switch to GROUP SHIP screen
ALL CLEAR ･････ Erase all registrations and switch to GROUP SHIP screen
EXIT ･･･････････ Return to SET UP menu
If [CLEAR] or [ALL CLEAR] are selected, Popup screen is appeared. (as shown below)
If [OK] is selected, the registration is deleted.
If [CANCEL] is selected, switch to previous screen.
Select [SAVE]
GROUP SHIP
1.
SHIP NAME:
MMSI:
000000000
1
/
10
SHIP NAME
A BCDEFGHIJKLMNOPQRSTU
V
W
XYZ. 0123456789
[
＼
]
_
"
#
$
%
&
'
(
)
?
@
+-*
/
^
,:;<=>
!
[
C
]
[
AC
]
[
OK
]
[
EXIT
]
GROUP SHIP
1.
SHIP NAME:
MMSI:
0 00000000
1
/
10
GROUP SHIP
*SUB MENU*
[
SAVE
]
[
CLEAR
]
[
ALL CLEAR
]
[
EXIT
]
GROUP SHIP
SAVE OK
[
OK
]
GROUP SHIP
ARE YOU SURE
?
[
OK
]
[
CANCEL
]