- xix -
3.8.4 Set Navigation Information (User Map Setting) .................................3-93
3.8.5 Set and Display Geodetic System................................................... 3-100
3.9 APPLIED OPERATIONS..................................................................... 3-102
3.9.1 Set Radar Signal Processing (Process Setting) .............................. 3-102
3.9.2 Set Radar Trails (RADAR Trails Setting) ......................................... 3-105
3.9.3 Set Cursor (Cursor Setting)............................................................. 3-110
3.9.4 Set Screen(Screen Setting)............................................................. 3-112
3.9.5 Set Scanner (TXRX Setting) ...........................................................3-122
3.9.6 Set Chart Display (Map Setting)......................................................3-124
3.9.7 Set LORAN C (LORAN C Correction) ............................................. 3-136
3.10 USE FUNCTION SWITCH [FUNC] ..................................................... 3-137
3.10.1 Operation Procedure .....................................................................3-137
3.10.2 Function Setting Menu Items.........................................................3-138
3.10.3 Overview of Function Operations .................................................. 3-139
3.10.4 Overview of Stored Function Setting Data..................................... 3-143
3.10.5 Personal Information (PIN Setting)................................................3-144
3.11 USING CARD......................................................................................3-147
3.11.1 Save in and Transfer to Card (MEM CAPA/Copy) ......................... 3-148
3.11.2 Erase/Initialize Card Memory (CLR MEM/INIT Card) .................... 3-153
4. MEASUREMENT OF RANGE AND BEARING
4.1 MEASUREMENT USING THE CURSOR WITH THE TRACKBALL........4-1
4.2 MEASUREMENT BY RANGE RINGS.....................................................4-2
4.3 MEASUREMENT BY EBLS AND VRMS.................................................4-3
4.4 MEASUREMENT BETWEEN TWO OPTIONAL POINTS ....................... 4-4
5. OPERATION OF TT AND AIS
5.1 PREPARATION ....................................................................................... 5-2
5.1.1 Collision Avoidance ............................................................................. 5-3
5.1.2 Definitions of Symbols.........................................................................5-6
5.1.3 TT Data Display................................................................................. 5-11
5.1.4 Cursor Modes (Cursor)...................................................................... 5-13
5.1.5 Setting Collision Decision Criteria (CPA/TCPA Limit) ........................5-14
5.1.6 Setting CPA Ring (CPA Ring) ............................................................5-15
5.1.7 Setting Vectors (Vector Time).......................................................... 5-16
5.1.8 Setting the GPS antenna location ................................................... 5-17
To Next Page
Loading...
