JRC JMA-5212-4/6 - 7.3 SETTINGS; 7.3.1 Communication Port Setting (COM Port Setting)

723
7.3 SETTINGS
This section describes the electrical adjustment procedures to be performed by service engineers during system
installation.
7.3.1 Communication Port Setting (COM Port Setting)
External sensor signals are input to the radar equipment through a communication port. The radar equipment
has five communication ports. For signals to be input from sensors or to be output to the sensors,
communication ports need to be set in accordance with the sensors.
CAUTION
Do not carry out the adjustments of the equipment
except authorized service persons. If wrong setting is
carried out, this may cause unstable operation.
Do not carry out the adjustments during navigation.
Otherwise, the radar performance may be affected,
resulting in an accident or trouble.