8.4 REPLACEMENT OF MAJOR PARTS
836
8
yyyy
yyyy
Step 5: Connect the motor cables.
Reconnect the cables to the motor control
power circuit.
Step 6: Put the cover on.
Before attaching the cover to the antenna,
make sure that the gasket of the cover is not
deformed or cracked.
Also, remove any dust attached to the gasket.
Fix the cover with 4 hexagon bolts.
Failure to tighten the bolts or loose bolts will
affect waterproof property; therefore, make
sure to tighten all the bolts at the optimal
torque.
Turn on the antenna safety switch.
This completes the motor replacement procedure.
To Next Page
Loading...
Need help?
General
