5 – 23
When the target on which the vector and symbol are displayed needs not to be tracked or when the number
of vectors is reduced from the screen to easily see the target, an unnecessary target can be erased one by one.
When acquition is resumed from the beginning for all target, all target can also be erased.
5.7.1 Erasing a Target per Target
Procedures
1. Align the + cursor mark to the target to be erased.
2. Press the
TGT
CNCL
key.
The target vector and symbol disappear and only the radar image remains.
Specifying and erasing a target number
Procedures
1. Press the
TGT
DATA
key.
2. Press the
0
to
9
keys to specify a target number.
3. Press the
TGT
CNCL
key.
The vector and symbol of the specified target disappear and only the radar image
remains.
5.7.2 Erasing All Targets
When erasing all targets, the tracking of all the targets must be stopped and new automatic or manual
acquisition must be resumed. So use this function only when necessary.
Procedures
Continue pressing the
TGT
CNCL
key for two seconds or more.
All vectors and symbols are erased.
5.7 Erasing an Unnecessary Target
Attention
To Next Page
Loading...
Need help?
General
