3
3 – 48
3.3
3.3.23.7 Setting Vector Time
This function is used to set the vector length.
The default setting is 6 minutes.
The vector time information is always displayed on the screen.
Procedures
1. Press the
SUB
MENU
key to open the SUBMENU.
2. Press the
3
key to open the RADAR #3 menu.
3. Press the
3
key to open the EPA menu.
4. Press the
1
key to select VECTOR TIME.
5. Press the
1
key to enable the vector time to be entered.
6. Enter the vector time (0 to 60 minutes) using numeric keys (
0
to
9
).
7. Press the
ENT
key to confirm the setting.
Exit
8. Press the
SUB
MENU
key.
or
Procedures
Press the
VECT+
or
VECT–
DEST
key to increase or decrease the vector time every
minute.
EPA
1. VECTOR TIME 6MIN (0-60 MIN)
2. PLOT NUMBER OFF
ON
3. LIMITS CPA 1NM (0.1-9.9 NM. )
TCPA 15MIN (1-99 MIN)
4. AUDIBLE WARNING OFF
ON
5. DISPLAY OF CPA RING OFF
ON
EPA 0. PREV
Attention
To Next Page
Loading...
