JRC JMA-7725-6 - Setting the Storage Interval

5.10
5 – 35
5.10.5 Setting the Storage Interval
This setting is valid when target past track function is ON.
Setting this function to OFF does not store target past track. In this case, the display of target past
track is continued until the screen is rewritten by changing the range, etc.
Procedures
1. Press the
SUB
MENU
key to open the SUB MENU.
2. Press the
7
key to open the ATA TRACK menu.
3. Press the
5
key to select "TRK MEM INTERVAL".
4. Press the
5
key to select an interval.
5. Press the
ENT
key to fix this setting.
Exit
6. Press the
SUB
MENU
key to close the ATA TRACK menu.
ATA TRACK
1. TRACK FUNCTION OFF ON
2. TRACK COLOR
ALL0123456789OTHER
WHT SKY BLU GRN YEL PNK RED WHT WHT WHT WHT
3.
4. TRK DISPLAY
ALL0123456789OTHER
5. TRK MEM INTERVAL OFF 10SEC 30SEC
1MIN 3MIN 5MIN 10MIN
Attention
ATA TRACK 0. PREV
9. NEXT