JRC JMR-5425-7X - Setting Parallel Index Lines in the Operation Unit; Operation in [All] Mode

4-25 Section 4 Range and Bearing Measurement Methods
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
1
4.6.7 Setting parallel index lines in the operation
unit
The bearing and interval of parallel index lines can be set with the [EBL] and [VRM] dials.
1 Press the [PI] key to display the [PI Menu] dialogue box.
2 By turning the [EBL] dial, set up bearing.
Turning the [EBL] dial to the right changes the bearing of parallel index lines in the right bearing
[1] and turning it to the left changes in the left bearing [2].
3 By turning the [VRM] dial, set up the interval of parallel index lines.
Turning the [VRM] dial to the left narrows the interval of parallel index lines [3] and turning it to
the right widens the interval [4].
4 Press the [PI] key to close the [PI Menu] dialogue box.
The parallel index lines are fixed.
The operation and motion of the parallel index differ depending on the motion mode in the [PI Menu]
dialogue.
4.6.7.1 Operation in [All] mode
[Operating the [EBL] dial]
By using the [EBL] dial, the bearing of the index lines can be changed.
[Operating the [VRM] dial]
By using the [VRM] dial, the interval of the index lines can be changed.
[1]
[2]
[3]
[4]