JRC JMR-5425-7X - Operation in [Individual] Mode; Operation in [Track] Mode

Section 4 Range and Bearing Measurement Methods 4-26
4.6.7.2 Operation in [Individual] mode
In [Individual] mode, the index line that is selected in the [Index Line] combo box is operated.
[Using the [EBL] dial]
By using the [EBL] dial, the bearing of the index line can be changed.
Setting parallel index lines consecutively by using the [EBL] dial
When [Sequential] is checked, the floating mode is set. When [Screen Fix] or [L/L Fix] is selected, the
parallel index line to be set is switched in the sequence of Index Line1→2→•••→8→1•••, enabling
consecutive setting.
Memo
The index lines that are set to be hidden by selecting [View] - [Tools] on the menu are skipped
during operation.
[Operating the [VRM] dial]
By using the [VRM] dial, the interval of the index lines can be changed.
The reference point for changing the interval can be an end point 1 or 2 of the index line or the
reference point on the line.
Whenever the [VRM] dial is pressed, the reference point is selected in the sequence of "end point
1→end point 2→reference point on the line→•••"
End point 1
End point 2
Reference point on the line
As a result of the selection, the
distance from the reference
point to the end point 1 on the
line changes.
As a result of the selection, the
distance from the reference
point to the end point 2 on the
line changes.
As a result of selection, the
interval from the reference point
to the index line changes.
4.6.7.3 Operation in [Track] mode
The index lines of the group that is selected in [Group] combo box are operated in [Track] mode.
[Operating the [EBL] dial]
By using the [EBL] dial, the bearing of the index lines can be changed.
[Operating the [VRM] dial]
By using the [VRM] dial, the interval of the index lines can be changed.
Reference point on the line
End point 2
End point 1