JRC JMR-5425-7X - Creating a Line (Line Object); Mark

10-17 Section 10 Creating a User Map
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
10.6.2 Creating a line (Line object)
The line is created by using one vertex as one object.
1 Click on the [Type] button on the drawing toolbar.
An icon list is opened. Select an icon of the line. (Refer to "10.5.3 Selecting an object type").
2 Click on the starting point with the cursor.
A vertex is created and the property information of the vertex is displayed on the object property
dialogue.
3 Move the cursor to the next vertex.
The latitude and longitude of the cursor are displayed near the cursor.
4 Click on the position on which the 2
nd
vertex is to be created.
A vertex is created and the parameters of the 2
nd
vertex are displayed on the object property
dialogue.
5 Determine the Line by double-clicking on the button or right-clicking the button.
6 Adjust the parameters on the object property dialogue.
7 To create an object on another position continuously, repeat Steps 2 to 6.
Memo
The property screen for the vertex that was created can be edited in AUTO mode.
For the details of AUTO mode, refer to "3.15 Cursor AUTO Mode".
Double-click
[Edit User Map] button
Mark
Mark
Determined with the line up to
the last vertex that was set
Releasing the starting
point selection state
Mark
Addition of 2
nd
point