JRC JMR-5425-7X - Page 347

11-3 Section 11 Setting up Screen View
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
付録
• To display COG (Course Over the Ground) vector, select [Ground stabilised vector] in [Vector].
• To display the HDG (ship’s heading) vector, select [Sea stabilised vector] in [Vector].
For details on the setting of type and length of the vector to be displayed, refer to the following table.
Setting Item
Description of Setting
Setting Value
Type Select an own ship symbol from the combo box
(symbols of other ships are also linked).
: Outline
: Minimised Symbol
Outline
Minimised Symbol
Stern Line Enable the display of stern line by selecting this
item.
To enable: Select.
To disable: Clear.
Ground stabilised vector
(Display of ship speed
relative to land)
Enable the display of ship speed relative to land by
selecting this item.
To enable: Select.
To disable: Clear.
Sea stabilised vector
(Display of ship speed
relative to water)
Enable the display of ship speed relative to water by
selecting this item.
To enable: Select.
To disable: Clear.
Time (own ship vector
length)
Enter the time when the ship speed relative to water
is displayed in the box.
1 to 120 min
Stabilisation indicator
Selecting this enables to display the stabilisation
indicator.
Memo
Automatically enabled when both the display of ship
speed relative to ground and the display of ship
speed relative to water are enabled.
To enable: Select.
To disable: Clear.
Vector Time Mark Selecting this enables the interval of the vector time
mark.
To enable: Select.
To disable: Clear.
Interval Select an interval of the vector time mark from the
pulldown menu when [Vector Time mark] is enabled.
1 to 6 min
Shortcuts
Click on any of available shortcuts to display the related dialogue.
Shortcut Setup Dialogue
Setting of AIS Filter [Settings] – [Filter] dialogue
Settings of AZ [Alert] – [New Target Alarm] dialogue