– 21 –
Operating procedure
[Maintenance personnel level]
Press communication mode switch for approximately three seconds in the information screen.
Refer to [Information screen (Maintenance personnel level)
Pictograph on the left end of the communication screen is shown in reverse video.
Communication screen (Maintenance personnel level)
7. Communication setting
1 Data selection
Press data selection switch in the communication screen.
Data selection screen
Select the data to perform communication, and press set key switch .
2 Communication method selection
Press communication method selection switch in the communication screen.
Communication method selection screen
Kind of selected data
Data selection
Data communication
source
Data
communication
destination
Communication
method selection
Start of
communication
To Next Page
Loading...
Need help?
General
