– 63 –
,,
,,
,
Test display mode function (Function setting No. 102)
The I/O status can be examined at the CP panel.
This function is valid only at the time of maintenance. Never use it in regular operation.
The sewing machine can work normally. However, normal display cannot be presented at the control box or the
CP panel.
0: Function OFF
1 to 10: Function ON
For more details, please contact our nearby business office.
..
..
.
Touch back switch half-needle compensation function (Function setting No. 105)
When the IP-110 is connected and a corner pattern is selected in this condition, this function is used to perform
compensation sewing in the middle of in-corner sewing with the use of the touch back switch.
0: off Compensation sewing disabled with the touch back switch
1: on Compensation sewing enabled with the touch back switch
* Setting is possible only if LH-4168 or LH-4188 is selected for the machine head.
//
//
/
Presser lifter switch half-needle compensation function (Function setting No. 106)
When the IP-110 is connected and a corner pattern is selected in this condition, this function is used to perform
compensation sewing in the middle of in-corner sewing with the use of the presser lifter switch.
0: off Compensation sewing disabled with the presser lifter switch
1: on Compensation sewing enabled with the presser lifter switch
* Setting is possible only if LH-4168 or LH-4188 is selected for the machine head.
* When using this function, it is necessary to set up the presser lifter function selection (No.117) at 0 (function
disabled).
¡¡
¡¡
¡
In-Corner sewing one-shot function (Function setting No. 107)
When the IP-110 is connected and a corner pattern is selected in this condition, this function is used to perform
automatic one-shot sewing in the middle of in-corner sewing.
0: off Automatic one-shot sewing disabled during in-corner sewing
1: on Automatic one-shot sewing enabled during in-corner sewing
* Setting is possible only if LH-4168 or LH-4188 is selected for the machine head.
™™
™™
™
In-corner presser lifter function (Function setting No. 108)
When the IP-110 is connected and a corner pattern is selected in this condition, this function is used to perform
automatic presser rising after the completion of in-corner sewing.
0: off Automatic presser rising disabled after the completion of in-corner sew-
ing
1: on Automatic presser rising enabled after the completion of in-corner sewing
* Setting is possible only if LH-4168 or LH-4188 is selected for the machine head.
* This function is enabled only if the automatic presser lifter unit (AK) is connected.
To Next Page
Loading...
Need help?
General
