– 64 –
££
££
£
Re-sewing function (Function setting No. 109)
When the IP-100 is connected, this function is used to stop/use the re-sewing function (sewing retried in the
middle of operation).
0: off Re-sewing function disabled
1: on Re-sewing function enabled
* Setting is possible only if LH-4168 or LH-4188 is selected for the machine head.
¢¢
¢¢
¢
Unilateral needle selection function (Free stitching/ Overlapped stitching) (Function setting No. 110)
When a reverse or overlapped stitching pattern is selected, this function is used to stop/use the unilateral needle
selection function. When 0 (disable) is selected, unilateral needle selection is disabled for the reverse or over-
lapped stitching pattern.
0: off Unilateral needle selection function (during free stitching) disabled
1: on Unilateral needle selection function (during free stitching) enabled
* Setting is possible only if LH-4168 or LH-4188 is selected for the machine head.
Unilateral needle selection function (Corner Pattern) (Function setting No. 111)
When the IP-110 is connected and a corner pattern is selected in this condition, this function is used to stop/use
the unilateral needle selection function. When 0 (disable) is selected, arbitrary unilateral needle selection is
disabled for the corner pattern.
0: off Unilateral needle selection function (during corner pattern) disabled
1: on Unilateral needle selection function (during corner pattern) enabled
* Setting is possible only if LH-4168 or LH-4188 is selected for the machine head.
§§
§§
§
Selection of teaching operation (Function setting No. 112)
When the teaching switch is pressed, the resultant operation is selected.
0: Normal (Teaching operation is performed under the conditions of Teach-
ing + Unilateral Needle Selection.)
1: Teaching operation only by unilateral needle selection (It is unneces-
sary to press the teaching switch in order to start up the teaching opera-
tion.)
2: Teaching operation disabled in the unilateral needle state (Press the
teaching switch after the bilateral needle state has been assumed.)
* Setting is possible only if LH-4168 or LH-4188 is selected for the machine head.
55
Teaching operation disabled in the unilateral
needle state (Press the teaching switch after the
bilateral needle state has been assumed.)
To Next Page
Loading...
