JUKI TR6SNV - Page 30

Maintenance Guide
3-14
DIP switch 4: Revision of pattern functions
1 3: P_REV0
2 3: P_REV1
3 3: P_REV2
4 3: P_REV3
5 3: F_REV0
6 3: F_REV1
7 3: F_REV2
8 3: F_REV3
DIP switch 5: Spare
1 2: RFID
2 1: Spare
3 4: Specifies the shuttle pad when BGA is used.
4 4: Specifies the shuttle pad when BGA is used.
5 1: Spare
6 1: Spare
7 1: Spare
8 OFF: Normally fixed to OFF.
DIP switch 6: Spare
1 6: Spare
2 6: Spare
3 6: Spare
4 6: Spare
5 6 Spare
6 6: Spare
7 6: Spare
8 6: Spare
DIP switch 7: Spare
1 6: Spare
2 6: Spare
3 6: Spare
4 6: Spare
5 6: Spare
6 6: Spare
7 6: Spare
8 6: Spare
DIP switch 8: Spare
1 6: Spare
2 6: Spare
3 6: Spare
4 6: Spare
5 6: Spare
6 6: Spare
7 6: Spare
8 6: Spare

1. The setting is made according to the
software specifications, such as special
order.
Make the same setting as that on the
previous PCB.
2. Make the setting after checking the
machine specifications.
3. The setting has been made at shipment of
the PCB. So, the setting is not needed.

5. Set ON only for 40137756.
Set OFF for other machines.

4 If the shuttle BGA is used, you can specify
a desired shuttle pad by selecting the
appropriate dip switch combination from
among the followings.
Shuttle pad selection
DIP SW 5_3
DIP SW 5_4
Large pad
ON
ON
Large pad
OFF
OFF
Small pad
OFF
ON
According to the head
ON
OFF

6. The setting is made according to the
software specifications, such as special
order.
For settings, check individually.