Operator's responsibility - safety instructions
11
6.3 Operating the unit
The bath may be filled with flammable materials. Fire hazard!
Chemical dangers may occur, depending on the bath medium.
Refer to all warnings on the substances used (bath fluids) and in the
relevant instructions (safety data sheets).
The formation of explosive mixtures is possible if the ventilation is
inadequate.
Only use the units in well ventilated areas. The unit is not suitable
for use in potentially explosive environments.
Special substance specifications (bath fluids) must be observed for
correct operation. Caustic or corrosive bath fluids must not be used.
When using hazardous substances or substances which may be
hazardous, the operator must apply the enclosed safety symbols (1
+ 2a or 2b) on the control side panel where they are clearly visible:
1
Warning of a danger zone. Attention!
Observe documentation. (Operating manual, safety data sheet)
It is essential that you read the user information prior to operation.
Area of validity: EU
It is essential that you read the user information prior to operation.
Area of validity: USA, NAFTA
As a result of the wide range of operating temperatures, special care
and caution is essential.
There are thermal dangers: Burns, scalds, hot steam, hot parts and
surfaces which may be touched.
Warning about hot surfaces.
(The label is applied by JULABO)
If external units are connected
Refer to the instructions in the manuals for the external units which
you connect to the JULABO unit, particularly the safety instructions.
The connection assignment of the plugs and the technical data for
the products must be observed at all times.
To Next Page
