Safety instructions
8
5 Safety instructions
It is important to follow these safety instructions to prevent personal
injury and property damage. These instructions apply in addition to
standard safety practices for working places.
• It is essential that you read the user information before starting
the unit.
• Use PPE (safety gloves, safety shoes, safety goggles).
• Transport the unit carefully. The interior of the unit can also be
damaged by impacts or if it is dropped.
• Do not loiter under the unit during transportation and operation.
• The unit is not intended for use in potentially explosive areas.
• Please observe the specifications for the minimum space
requirement when setting up the unit.
• Only operate the unit in rooms that are well-ventilated, dry and
free of frost.
• Switch the unit off immediately if there is refrigerant leakage.
• Place the unit on a flat surface of non-flammable material.
• Operate the unit under an exhaust hood as much as possible.
• Do not start the unit if it is damaged or leaking.
• Compare the mains voltage and frequency with the
specifications on the type plate.
• Only connect the unit to a fused mains connection via a FI circuit
breaker (Ia=30 mA).
• Only connect the unit to a power socket with ground contact (PE
–protective earth)!
• The power supply plug serves as safe disconnecting device from
the power supply network and must be freely accessible at all
times.
• Check the mains cable regularly for signs of damage.
• Do not start the unit if it has a damaged power cable.
• Keep the mains cable away from hot pump connections.
• Refer to the safety sticker. Parts of the unit can be hot or cold.
• Never use the unit without enough bath fluid.
• Do not reach into the thermal bath fluid.
• Check the filling level of the bath fluid at regular intervals. The
pump and heater must always be completely covered with bath
fluid.
To Next Page
Loading...
