Operation via the USB or RS232 interface
40
IN_MODE
in_mode_05 Unit in stop/start condition:
0 = stop; 1 = start
Special parameter
version Firmware version.
status Status / Error
OUT-SP
out_sp_00 Adjustment of the setpoint. xxx.xx
out_sp_07* Set pump to factory settings 1 ... 5.
out_sp_27 Adjust the pump stepless (%)
* do not use for reprogramming, see out_sp_27. At pump level 4, the outlet pressure is approx.
450 mbar.
Pump chacteristic (steps 1-5)
To Next Page
Loading...
