To Next Page

To Previous Page

C 1

1004.GB

C Transport and Commissioning

1 Lifting by crane

Only use lifting gear with sufficient capacity (for transport weight see truck data plate).

The attachment points (1) are provided for lifting the truck with crane lifting gear (in

the middle with the ZZ mast).

– Park the truck securely (see Chapter E).

– Strap the lifting gear onto the attachment

points (1) (in the middle with the ZZ

mast).

Attach the crane slings to the strap points

so that the truck cannot slip. Lifting slings

should be fastened in such a way that they

do not come into contact with any parts of

the truck when it is being raised.

2 Commissioning

Operate the truck only with battery current. Rectified AC current will damage the

electronic components. The battery leads (tow cable) must be less than 6m long.

It is forbidden to raise loads if the truck is operated via a tow lead with an external

battery.

To prepare the truck after delivery or after transport, proceed as follows:

– Check the truck for completeness and satisfactory condition of the equipment.

– Install battery (where required). Do not damage battery cable.

(see chapter D).

Set the characteristic curve (charging curve) on the charger (see Chapter D).

– Charge the battery (see Chapter D).

– If necessary, adjust the combination instrument to match the battery type (see

Chapter D).

– Start up the truck as indicated.

(see Chapter E).

When the truck is parked, the running surface of the tyres will flatten. The flattening

will disappear after a short operating time of the truck.

C 1