E 13
0606.GB
5.1 Parking the truck securely
When you leave the truck it must be securely parked even if you only intend to leave
it for a short time.
F
Do not park the truck on a slope. The load forks must always be lowered to the
ground.
– Lower the load forks.
– Set the key switch (2) to “0” and remove the key or press “o” for CANCODE.
6 Keypad (CANCODE) (o)
The keypad consists of 10 number keys, a Set
key and an extra key o.
Activation of the travel programs via switches
1,2,3 is indicated by green LEDs.
The o key indicates operating statuses via a red/
green LED.
It contains the following functions:
– Code lock function (commissioning the truck).
– Travel program selection.
– Setting the travel and battery parameters, only in conjunction with the display
instrument (CANDIS (o)).
The o key has top priority and resets the truck from any condition to its default
condition without modifying any settings.
6.1 Code Lock
When the correct code has been entered, the machine is ready for use. You can
allocate an individual code to each truck, driver or group of drivers.
M
When delivered from the factory, the operator code (factory setting 2-5-8-0) is
indicated on a removable sticker.
Z
When starting the truck for the first time, change the master and operating codes.
(refer to section 6.4).
1 2 3
4 5 6
7 8 9
0
Set
E 13
0606.GB
5.1 Parking the truck securely
When you leave the truck it must be securely parked even if you only intend to leave
it for a short time.
F
Do not park the truck on a slope. The load forks must always be lowered to the
ground.
– Lower the load forks.
– Set the key switch (2) to “0” and remove the key or press “o” for CANCODE.
6 Keypad (CANCODE) (o)
The keypad consists of 10 number keys, a Set
key and an extra key o.
Activation of the travel programs via switches
1,2,3 is indicated by green LEDs.
The o key indicates operating statuses via a red/
green LED.
It contains the following functions:
– Code lock function (commissioning the truck).
– Travel program selection.
– Setting the travel and battery parameters, only in conjunction with the display
instrument (CANDIS (o)).
The o key has top priority and resets the truck from any condition to its default
condition without modifying any settings.
6.1 Code Lock
When the correct code has been entered, the machine is ready for use. You can
allocate an individual code to each truck, driver or group of drivers.
M
When delivered from the factory, the operator code (factory setting 2-5-8-0) is
indicated on a removable sticker.
Z
When starting the truck for the first time, change the master and operating codes.
(refer to section 6.4).
1 2 3
4 5 6
7 8 9
0
Set
To Next Page
Loading...
