Jungheinrich EJC 112 User Manual

0606.GB
E 16
6.4 Parameter Settings
To change the truck setting you must enter the master code.
Z
The factory setting for the master code is 7-2-9-5.
M
When starting the truck for the first time, change the master code.
F
Safety instructions for trucks with a display instrument (CANDIS (o))
– Parameter settings must be made carefully and only by special trained personnel.
If in doubt, consult the manufacturer's service department.
– Each setting must be monitored on the LC display of the display instrument
(CANDIS (o)). If in doubt, cancel the setting by pressing the o-key (20).
– Since changing any parameter will affect the truck's travel pattern, you must carry
out a test run in a specially designated work area.
To enter the master code:
– Press the o key
– Enter master code
Code Lock Parameters
Setting procedure for trucks without a display instrument (CANDIS (o)):
– Enter the three digit parameter number, confirm with set key (16).
– Enter the setting according to the parameter list or change and confirm with the Set
key (16).
Z
If the entry is incorrect, the LED (15) of the o key (20) turns red. When you enter the
parameter number again the setting can be entered or changed.
To enter more parameters, repeat the procedure. To finish entering, press the o key
(20).
Display instrument
(CANDIS)
LED (15)
o key
LED (17)
Key 1
LED (18)
Key 2
LED (19)
Key 3
Service hours
are indicated
284.0
Green
flashing
Off Off Off
0606.GB
E 16
6.4 Parameter Settings
To change the truck setting you must enter the master code.
Z
The factory setting for the master code is 7-2-9-5.
M
When starting the truck for the first time, change the master code.
F
Safety instructions for trucks with a display instrument (CANDIS (o))
– Parameter settings must be made carefully and only by special trained personnel.
If in doubt, consult the manufacturer's service department.
– Each setting must be monitored on the LC display of the display instrument
(CANDIS (o)). If in doubt, cancel the setting by pressing the o-key (20).
– Since changing any parameter will affect the truck's travel pattern, you must carry
out a test run in a specially designated work area.
To enter the master code:
– Press the o key
– Enter master code
Code Lock Parameters
Setting procedure for trucks without a display instrument (CANDIS (o)):
– Enter the three digit parameter number, confirm with set key (16).
– Enter the setting according to the parameter list or change and confirm with the Set
key (16).
Z
If the entry is incorrect, the LED (15) of the o key (20) turns red. When you enter the
parameter number again the setting can be entered or changed.
To enter more parameters, repeat the procedure. To finish entering, press the o key
(20).
Display instrument
(CANDIS)
LED (15)
o key
LED (17)
Key 1
LED (18)
Key 2
LED (19)
Key 3
Service hours
are indicated
284.0
Green
flashing
Off Off Off

Jungheinrich EJC 112 Specifications

General

Brand	Jungheinrich
Model	EJC 112
Category	Lifting Systems
Language	English