Jungheinrich EJC 112 User Manual

0606.GB
E 8
4.2 Travelling, Steering, Braking
F
Never carry passengers.
Emergency Stop
– Remove the battery connector (1).
All electrical functions are deactivated.
Automatic braking
Automatic braking occurs when the tiller is released – the tiller automatically sets
itself to the upper brake zone (B).
F
If the tiller moves slowly to the upper brake zone, the cause of this fault must be
rectified. If necessary, replace the gas pressure spring.
Travel
M
Travel with raised forks / raised load beyond 500 mm above the ground is prohibited.
M
Do not drive the truck unless the panels are closed and properly locked.
– Start up the truck (refer to section 3).
The travel speed is governed by the travel switch (7).
– Set the tiller (5) to the travel range (F) and press the travel switch (7) in the desired
direction (fwd. or rev.).
0
B
F
B
7
6
1
5
R
R
V
V
0606.GB
E 8
4.2 Travelling, Steering, Braking
F
Never carry passengers.
Emergency Stop
– Remove the battery connector (1).
All electrical functions are deactivated.
Automatic braking
Automatic braking occurs when the tiller is released – the tiller automatically sets
itself to the upper brake zone (B).
F
If the tiller moves slowly to the upper brake zone, the cause of this fault must be
rectified. If necessary, replace the gas pressure spring.
Travel
M
Travel with raised forks / raised load beyond 500 mm above the ground is prohibited.
M
Do not drive the truck unless the panels are closed and properly locked.
– Start up the truck (refer to section 3).
The travel speed is governed by the travel switch (7).
– Set the tiller (5) to the travel range (F) and press the travel switch (7) in the desired
direction (fwd. or rev.).
0
B
F
B
7
6
1
5
R
R
V
V

Jungheinrich EJC 112 Specifications

General

Brand	Jungheinrich
Model	EJC 112
Category	Lifting Systems
Language	English