Jungheinrich EJC 112 - 5 Emergency lowering

0606.GB
E 12
5 Emergency lowering
F
Keep all personnel out of the hazardous area when applying emergency lowering.
If the mast cannot be lowered any further due to a fault in the combination controller,
manually apply the valve (14) on the hydraulic unit.
– Set key switch (2) to “0”.
– Disconnect the battery (see chapter
D).
– Open the front panel (see Chapter F,
Section 6.3).
– Unscrew the cap (14.1).
– Retract the valve slide (14.2) as far as
the stop.
– Push in the valve slide (14.3) and pin
(3mm) gradually and keep it pressed
down.
The lifting device lowers.
– Insert the valve slide (14.2) as far as the stop.
– Fit the cap (14.1).
F
Only operate the truck once the fault has been removed.
14.1
14.2
14.3
0606.GB
E 12
5 Emergency lowering
F
Keep all personnel out of the hazardous area when applying emergency lowering.
If the mast cannot be lowered any further due to a fault in the combination controller,
manually apply the valve (14) on the hydraulic unit.
– Set key switch (2) to “0”.
– Disconnect the battery (see chapter
D).
– Open the front panel (see Chapter F,
Section 6.3).
– Unscrew the cap (14.1).
– Retract the valve slide (14.2) as far as
the stop.
– Push in the valve slide (14.3) and pin
(3mm) gradually and keep it pressed
down.
The lifting device lowers.
– Insert the valve slide (14.2) as far as the stop.
– Fit the cap (14.1).
F
Only operate the truck once the fault has been removed.
14.1
14.2
14.3