Jungheinrich EJC 112 - Page 46

E 17
0606.GB
Setting procedure for trucks with and without display instrument (CANDIS (o)):
– Enter the three digit parameter number, confirm with the Set key (16).
– The display instrument (CANDIS (o)) continues to display the operating hours. If
the display changes, cancel the setting with the o-key (20) and restart from the
beginning.
– Enter the setting according to the parameter list or change and confirm with the Set
key (16).
Z
If the entry is incorrect, the LED (15) of the o key (20) turns red. When you enter the
parameter number again the setting can be entered or changed.
To enter more parameters, repeat the procedure. To finish entering, press the o key
(20).
The following parameters may be entered.
Code Lock Parameter List
No. Function Setting Range Standard
Setting
Comments
Procedure
Code Lock
000 Change Master Code
The length (4-6 digits) of
the master code also pre-
determines the length of
the operator code (4-6
digits). Provided the
operator codes are
programmed, only news
codes of the same length
can be entered. If the
code length is changed,
all operator codes must
be deleted beforehand.
0000 - 9999
or
00000 - 99999
or
000000 - 999999
7295 (LED 17 flashes)
Enter
current code
Confirm (Set)
(LED 18 flashes)
Enter
new code
Confirm (Set)
(LED 19 flashes)
Repeat new code
Confirm (Set)
001 Add operator code (max.
600)
0000 - 9999
or
00000 - 99999
or
000000 - 999999
2580 (LED 18 flashes)
Enter
code
Confirm (Set)
(LED 19 flashes)
Repeat
code entry
Confirm (Set)
E 17
0606.GB
Setting procedure for trucks with and without display instrument (CANDIS (o)):
– Enter the three digit parameter number, confirm with the Set key (16).
– The display instrument (CANDIS (o)) continues to display the operating hours. If
the display changes, cancel the setting with the o-key (20) and restart from the
beginning.
– Enter the setting according to the parameter list or change and confirm with the Set
key (16).
Z
If the entry is incorrect, the LED (15) of the o key (20) turns red. When you enter the
parameter number again the setting can be entered or changed.
To enter more parameters, repeat the procedure. To finish entering, press the o key
(20).
The following parameters may be entered.
Code Lock Parameter List
No. Function Setting Range Standard
Setting
Comments
Procedure
Code Lock
000 Change Master Code
The length (4-6 digits) of
the master code also pre-
determines the length of
the operator code (4-6
digits). Provided the
operator codes are
programmed, only news
codes of the same length
can be entered. If the
code length is changed,
all operator codes must
be deleted beforehand.
0000 - 9999
or
00000 - 99999
or
000000 - 999999
7295 (LED 17 flashes)
Enter
current code
Confirm (Set)
(LED 18 flashes)
Enter
new code
Confirm (Set)
(LED 19 flashes)
Repeat new code
Confirm (Set)
001 Add operator code (max.
600)
0000 - 9999
or
00000 - 99999
or
000000 - 999999
2580 (LED 18 flashes)
Enter
code
Confirm (Set)
(LED 19 flashes)
Repeat
code entry
Confirm (Set)