Jungheinrich EJC 112 - Page 43

0606.GB
E 14
Starting the truck for the first time
The LED (15) goes red when you connect the battery and if necessary switch on the
key switch.
When you enter the correct operator code (factory setting 2-5-8-0) the LED (15) turns
green.
If the wrong code is entered LED (15) flashes red for two seconds. The correct code
can then be entered.
Z
The Set key (16) has no function in operating mode.
Switching off
To switch the truck off, press the o key (20).
Z
The truck can switch off automatically after a
pre-determined time. To do this, you need to
set the corresponding code lock parameter.
(see section 6.4).
1 2 3
4 5 6
7 8 9
0
Set
17
16
15
20
1918
0606.GB
E 14
Starting the truck for the first time
The LED (15) goes red when you connect the battery and if necessary switch on the
key switch.
When you enter the correct operator code (factory setting 2-5-8-0) the LED (15) turns
green.
If the wrong code is entered LED (15) flashes red for two seconds. The correct code
can then be entered.
Z
The Set key (16) has no function in operating mode.
Switching off
To switch the truck off, press the o key (20).
Z
The truck can switch off automatically after a
pre-determined time. To do this, you need to
set the corresponding code lock parameter.
(see section 6.4).
1 2 3
4 5 6
7 8 9
0
Set
17
16
15
20
1918