Jungheinrich EJC 112 - Page 48

E 19
0606.GB
*
)
only in conjunction with display instrument (CANDIS (o))
only block if not start travel program.
Error messages on keypad
LED (15) flashes red to indicate the following errors:
– New master code is already operator code.
– New operator code is already master code.
– Operator code to be changed does not exist.
– Tried to change the operator code to another user code that already exists.
– Operator code to be deleted does not exist.
– Code memory full.
– Start program blocked.
– Travel program to be blocked is the start travel program.
No. Function Setting Range Standard
Setting
Comments
Procedure
Code Lock
020 Start travel program 1 - 3 2 1 = Travel program 1
2 = Travel program 2
3 = Travel program 3
021 Travel program 1
Enable
0 or 1 1 0 = Travel program
not enabled
1 = Travel program
enabled
022 Travel program 2
Enable
0 or 1 1 0 = Travel program
not enabled
1 = Travel program
enabled
023 Travel program 3
Enable
0 or 1 1 0 = Travel program
not enabled
1 = Travel program
enabled
030 Display of the number of
used operator codes*
)
E 19
0606.GB
*
)
only in conjunction with display instrument (CANDIS (o))
only block if not start travel program.
Error messages on keypad
LED (15) flashes red to indicate the following errors:
– New master code is already operator code.
– New operator code is already master code.
– Operator code to be changed does not exist.
– Tried to change the operator code to another user code that already exists.
– Operator code to be deleted does not exist.
– Code memory full.
– Start program blocked.
– Travel program to be blocked is the start travel program.
No. Function Setting Range Standard
Setting
Comments
Procedure
Code Lock
020 Start travel program 1 - 3 2 1 = Travel program 1
2 = Travel program 2
3 = Travel program 3
021 Travel program 1
Enable
0 or 1 1 0 = Travel program
not enabled
1 = Travel program
enabled
022 Travel program 2
Enable
0 or 1 1 0 = Travel program
not enabled
1 = Travel program
enabled
023 Travel program 3
Enable
0 or 1 1 0 = Travel program
not enabled
1 = Travel program
enabled
030 Display of the number of
used operator codes*
)