Juniper E Series User Manual

Tunnel Service Modules ! 155
Chapter 13: Protocol Support
Dynamic interfaces No No No
F4 OAM (ATM Administration) No No No
FDL (facilities data link) No No No
Frame Relay No No No
IP Yes Yes Yes
IP Multicasting No No No
IPSec No No Yes
IPv6 No No No
IS-IS Yes Yes Yes
LAC Support – access side No No No
LAC Support – peer side No No No
LNS Support – Internet side Yes Yes No
LNS Support – peer side Yes Yes No
Local loopback No No No
MDL (maintenance data link) No No No
MPLS No No No
Multilink Frame Relay No No No
Multilink PPP Yes
a
Yes
a
No
Network Address Translation
(NAT)
Yes Yes No
NBMA (multipoint ATM) No No No
OSPF Yes Yes Yes
Packet over SONET No No No
PPP Yes
a
Yes
a
No
PPPoE No No No
Remote loopback No No No
RIP Yes Yes Yes
SMDS (trunk encapsulation) No No No
Subscriber interfaces (static) No No No
Subscriber interfaces (dynamic) No No No
Transparent bridging No No No
VRRP No No No
a.The TSM and SM line modules support only dynamic configurations of these protocols, not static configurations.
Table 31: Tunnel Service modules (continued)
Protocol or Application
Tunnel Service
Line Module (TSM) Service Line Module (SM)
IPSec Service
Line Module

Juniper E Series Specifications

General

Brand	Juniper
Model	E Series
Category	Network Router
Language	English