Juniper EX9200

Replace number with the following values depending on the LCC configuration:
• 0 through 3, when T640 routers are connected to a TX Matrix router in a routing
matrix.
• 0 through 3, when T1600 routers are connected to a TX Matrix Plus router in a
routing matrix.
• 0 through 7, when T1600 routers are connected to a TX Matrix Plus router with 3D
SIBs in a routing matrix.
• 0, 2, 4, or 6, when T4000 routers are connected to a TX Matrix Plus router with
3D SIBs in a routing matrix.
local—(MX Series routers only) (Optional) Display hardware-specific information for the
local Virtual Chassis members.
member member-id—(MX Series routers and EX Series switches) (Optional) Display
hardware-specific information for the specified member of the Virtual Chassis
configuration. Replace member-id variable with a value 0 or 1.
models—(Optional) Display model numbers and part numbers for orderable FRUs and,
for components that use ID EEPROM format v2, the CLEI code.
node-device name—(QFabric systems only) (Optional) Display hardware-specific
information for the Node device.
satellite [slot-id slot-id | device-alias alias-name]—(Junos Fusion only) (Optional) Display
hardware information for the specified satellite device in a Junos Fusion, or for all
satellite devices in the Junos Fusion if no satellite devices are specified.
scc—(TX Matrix router only) (Optional) Display hardware information for the TX Matrix
router (switch-card chassis).
sfc number—(TX Matrix Plus router only) (Optional) Display hardware information for
the TX Matrix Plus router (switch-fabric chassis). Replace number variable with 0.
Additional Information The show chassis hardware detail command now displays DIMM information for the
following Routing Engines, as shown in Table 8 on page 204.
Table 8: Routing Engines Displaying DIMM Information
RoutersRouting Engines
MX240, MX480, and MX960 routersRE-S-1800x2 and RE-S-1800x4
M120 and M320 routersRE-A-1800x2
In Junos OS Release 11.4 and later, the output for the show chassis hardware models
operational mode command for MX Series routers display the enhanced midplanes FRU
model numbers—CHAS-BP3-MX240-S, CHAS-BP3-MX480-S, or
CHAS-BP3-MX960-S—based on the router. In releases before Junos OS Release 11.4,
the FRU model numbers are left blank when the router has enhanced midplanes. Note
Copyright © 2016, Juniper Networks, Inc.204
Port Mirroring Feature Guide for EX9200 Switches