Juniper EX9200

Table 10: show chassis pic Output Fields (continued)
Field DescriptionField Name
Status of the PIC. State is displayed only when a PIC is in the slot.
• Online— PIC is online and running.
• Offline—PIC is powered down.
State
PIC hardware version.PIC version
How long the PIC has been online.Uptime
(Multiservices PICs only) Services package supported: Layer-2 or
Layer-3.
Package
Port number for the PIC.Port Number
Type of cable connected to the port: LH, LX, or SX.Cable Type
Port-level information for the PIC.
• Port—Port number
• Cable type—Type of optical transceiver installed.
• Fiber type—Type of fiber. SM is single-mode.
• Xcvr vendor—Transceiver vendor name.
• Xcvr vendor part number—Transceiver vendor part number.
• Wavelength—Wavelength of the transmitted signal. Uplinks and
downlinks are always 1550 nm. There is a separate fiber for each
direction
• Xcvr Firmware—Transceiver firmware version.
PIC Port Information
(MX480 Router 100-Gigabit
Ethernet CFP)
Port-level information for the PIC.
• Port—Port number
• Cable type—Type of small form-factor pluggable (SFP) optical
transceiver installed. Uplink interfaces display -U. Down link
interfaces display -D.
• Fiber type—Type of fiber. SM is single-mode.
• Xcvr vendor—Transceiver vendor name.
• Xcvr vendor part number—Transceiver vendor part number.
• BX10-10-km bidirectional optics.
• BX40-40-km bidirectional optics.
• SFP-LX-40-km SFP optics.
• Wavelength—Wavelength of the transmitted signal. Uplinks are
always 1310 nm. Downlinks are either 1490 nm or 1550 nm.
PIC Port Information
(MX960 Router
Bidirectional Optics )
Copyright © 2016, Juniper Networks, Inc.392
Port Mirroring Feature Guide for EX9200 Switches