Juniper SRX5400 - Page 64

•
Line-rate throughput of up to 240 Gbps
•
Supports up to 32,000 queues per-slot
•
LAN-PHY mode at 10.3125 Gbps on a per-port basis
•
The ports are labeled as:
•
10-Gigabit Ethernet ports: 0/0 through 0/11 and 1/0 through 1/11
•
40-Gigabit Ethernet ports: 2/0 through 2/2 and 3/0 through 3/2
Hardware features
•
Optical diagnostics and related alarms
•
Two packet-forwarding engines, PFE0 and PFE1. PFE0 hosts PIC0 and PIC2. PFE1 hosts
PIC1 and PIC3.
•
Configurable LAN-PHY mode options per 10-Gigabit Ethernet port
•
Intelligent oversubscription services
NOTE: At any one time you can have only one of the following PIC combinations powered
on:
•
PIC0 & PIC1
•
PIC0 & PIC3
•
PIC2 & PIC1
•
PIC2 & PIC3
If you configure any of the following invalid PIC combinations, the chassis will set PIC0 &
PIC1 combination online.
•
PIC0 & PIC2
•
PIC1 & PIC3
Software features
OK/FAIL LED, one bicolor:
•
Solid green—MPC is functioning normally.
•
Blinking green—MPC is transitioning online or offline.
•
Red—MPC has failed.
10-Gigabit Ethernet LINK LED, one green per port:
•
Green—Link is up.
•
Off—Link is down or disabled.
40-Gigabit Ethernet LINK LED, one bicolor per port:
•
Green—Link is up.
•
Amber—Link is disabled.
•
Off—Link is down.
LEDs
56