JVC JY-HM360E - Operation Lock Feature

Operation Lock Feature
You can use this feature to prevent erroneous
camera operation.
.
AE LEVEL
MENU/THUMB
CANCEL
1
While in the Camera mode (when the
display screen appears), press and hold
the [CANCEL] button for 5 seconds or
longer.
0
The operation
lock turns on, and an operation
lock icon (r) appears on the display
screen.
.
P 13000K 1/ 100
F1. 6
0
dB
AE+6
00 : 00: 00.00
4030 20 10
0
0
Press the [CANCEL] button again for 5
seconds or longer to turn off the operation
lock.
Memo :
0
The operation lock feature is only valid in the
Camera mode.
(A P14 [Operation Modes] )
0
The power turns off and the operation lock is
disengaged.
0
The [CANCEL] button on the LCD monitor
section cannot be used to turn on/off (“On/Off”)
the operation lock feature.
0
The following remote operations are possible
even when the operation lock feature is turned
on (“On”).
0
Remote operation from the wired remote
control connected
to the [REMOTE] terminal.
0
Remote operation of the camera through
access via a browser on devices such as a
smartphone, tablet terminal, or PC.
Operation lock does not apply to the following
buttons and switches.
0
[POWER ON/OFF]
switch
0
TC [IN/OUT]
selection switch
0
All switches inside the LCD monitor door
(however, the operation of the [CH1/CH2]
adjustment knob will be locked.)
0
Zoom Lever at the Grip
0
Zoom Lever at the Handle
0
Focus/Zoom Ring
0
[FOCUS/ZOOM] Operation Switch
0
[FIX/VAR/OFF] zoom speed switch
0
Iris Dial
0
[REC] button
(at the top of the handle, on the grip
and at the bottom of the lens)
Memo :
0
The operation lock will also not apply to the
[REC]
button at the bottom of the lens if [Camera
Function] B [User Switch Set] B [Front REC] is
set to “Rec”.
40
Operation Lock Feature
Preparations