Selecting and Performing
Operations on Multiple
Clips
0
Multiple clips can be selected during thumbnail
screen or playback screen display.
0
After selecting multiple clips, perform
appending/deleting
of
OK mark, deleting of clips
using the action selection screen.
0
After selecting multiple clips, the selections will
be canceled by the following operations.
0
When [Deselect All] in the action menu is
selected
0
When exiting
Media mode from the thumbnail
screen
0
When removing the SD card
0
When switching the slot in use
Selecting Multiple Clips Randomly
1
Move the cursor to a clip without check
mark, and press the [
OIS/2] button.
A green check mark appears on the clip.
.
2
Repeat Step 1 to select multiple clips.
0
Multiple clips can be selected.
0
Press the
[LOLUX/3] button while the
multiple clips are selected.
0
Appends OK mark together:
[Add OK Mark]
B [Selected Clips]
0
Deletes OK mark together:
[Delete OK Mark
] B [Selected Clips]
0
Deletes selected clips together:
[Delete Clips
] B [Selected Clips]
Memo :
0
Selecting clips appended with check mark and
pressing the [OIS/2] button will cancel the
selection.
0
If the
operation is performed on multiple clips at
the same time, a progress bar appears. You can
stop the operation by pressing the Set button (R)
while the operation is in progress. However, it is
not possible to undo operations that are
completed.
Selecting Multiple Clips Consecutively
1
Press the [LOLUX/3] button.
2
Select “Select Range” in the action
selection screen, and press the Set button
(R).
.
3
Move the cursor to the beginning (or end)
of the range for multiple selection, and
press the Set button (R).
4
Move the cursor to the other end of the
range.
0
Magenta check marks appear on the clips
within the range. (Including clips that were
already selected.)
0
Gray check marks appear on selected clips
that are outside the range.
.
82
Selecting and Performing Operations on Multiple Clips
Playback
To Next Page
Loading...
