5
Stop backup recording.
0
Select [STBY] in [Main Menu]
B [System] B
[Record Set] B [Slot Mode] B [Backup Rec]
and press the Set button (R).
(A P106
[ Slot Mode ] )
0
You can also press the user button that is
assigned with “Backup Trig”.
(
A P90 [User Switch Set Item] )
0
Recording to slot B stops, and the card slot
mark of
slot B turns white (unselected state).
0
The characters “BACKUP” changes back to
white.
0
The status indicator of slot B lights up in
green.
.
P13000K
1/100
F1. 6
0
dB
AE+6
12 :34 :56
Jan 12, 2016
00:00: 00.00
4030 20 10 0
5 . 6 f t
100min
50min
100min
50min
White
Memo :
0
During backup recording, if the space of one
card runs out, recording stops only for the card
that is full.
0
When recording to both slots is stopped,
recording in
the Regen mode will be enabled for
the card slot in which recording started.
0
When recording is started in the other slot while
recording to one slot, the clip being recorded is
split and simultaneous recording to the other
card starts.
0
When recording
is stopped for either slot A or B
while recording to both slots, the clip on the slot
which is still recording is split.
0
Although the clips are separated during
recording the
clips can be seamlessly joined by
arranging them on the timeline of the editing
software since they are recorded seamlessly.
0
Clip Cutter Trig cannot be performed during
backup recording.
(A P67 [Splitting the Clips Freely (Clip Cutter
Trig)] )
0
When [Slot Mode] is set to “Backup”, [Rec
Mode] can only be set to “Normal”.
(A P106
[ Rec Mode ] )
Special Recording
Besides the normal recording mode, four special
recording methods are available in this camera
recorder. They are Pre Rec, Clip Continuous,
Frame Rec and Interval Rec.
Memo :
0
Set using [
Main Menu] B [System] B [Record
Set] B [Rec Mode].
(A P
106 [ Rec Mode ] )
Pre Rec
0
By setting
the number of seconds in the [Pre Rec
Time], you can start recording video and audio
before actual recording starts based on the [Pre
Rec Time] setting.
0
When
starting
actual recording while the camera
recorder is in Recording Standby (STBYP)
mode, you can start recording a few seconds
earlier based on the [Pre Rec Time] setting.
0
Using Pre Rec allows you to record a complete
event without missing the initial scenes even if
you start the recording late.
Memo :
0
Pre Rec Time can be set to “5sec”, “10sec”, or
“15sec” in [Main Menu]
B [System] B [Record
Set] B [Rec Mode] B [Pre Rec Time].
0
When the frame rate setting in
[Main Menu]
B
[System] B [Record Set] B [Record Format] B
[Frame & Bit Rate] is set to “XHQ”, “15sec”
cannot be selected.
(A P
106 [ Pre Rec Time ] )
.
(Recording stops)
Press [REC]
(Recording starts)
Press [REC]
Recording starts a
number of seconds
earlier based on the
[Pre Rec Time] setting
(Recorded video and audio)
Completed Clip
Backup Rec
71
Shooting
To Next Page
Loading...
