JVC TK-C9510E - Page 15

Rear
.
INT/VL
B
D
E
F
C
A
H
I
J
K
L
G
TK-C9511EG
A [VIDEO OUT] Video signal output terminal
B [SYNC IN] Synchronizing signal input terminal
C AC 220 V - AC 240 V power cord (TK-C9511EG)
D AC 24 V, DC 12 V power input terminal (TK-C9510E)
E [TX+ E, TX- F, RX+ G, RX- H] Control signal connectors
(RS-485-compliant)
F AUX, GND connectors
G [MENU] button
H Cross key, [SET] button, [FOCUS ADJUST] button
Memo
Press the [SET] button down vertically. If the button is pressed
down at an angle, the operation may not be performed.
I [IRIS VIDEOlDC] Lens selector switch
J [RX TERM OFFlON] RX terminal ON/OFF switch
K [EXT TERM OFFlON] External synchronous terminal ON/OFF
switch
L [LLlINT/VL] Synchronous system selection switch
Introduction
E-15