User manual Product description
Kaba Terminal 9420 MID k1evo706en-2011-07 15
3.9.2 Network connection
The network connection to the terminal must be in place and must have been
checked by the IT department. In order to connect the terminal easily, the network
cable must project approx. 15 to 18 cm out of the wall. The RJ-45 plug must be
fitted.
3.9.3 Power supply
If a 230 V power supply is used, it must be prepared by a qualified electrician. The
power supply is connected directly to the connection terminal on the terminal (also
by the qualified electrician).
For details of the connection terminals see section 4.4, page 18.
If the power supply is a PoE (Power over Ethernet) system, the relevant standards
must be adhered to. For more information, see section 3.8, page 12.
To Next Page
Loading...
