MULTICAL® 803
Kamstrup A/S · Technical description · 5512-2360_A1_GB_02.2019
The registers which are connected to the pulse inputs can be read in the calculator’s TECH loop, in USER loop
(depending on selected DDD code) and via data communication. Furthermore, it is possible to pre-set the meter
count of the four pulse inputs to the values that the connected meters have at the time of the commissioning. This
can be done either via the calculator’s SETUP loop (for A1 and B1) or via METERTOOL HCW (for A1, B1, A2 and B2).
To Next Page
