Instructions for use DSE Expert
6 Service and Care | 6.1 Servicing
Filling the pressurised water bottle with the aid of the dosing facility
▶ Wipe up any spilled OXYGENAL immediately in order to prevent discolouration of
the surfaces.
▶ Remove the protective hose from the tube of the KaVo OXYGENAL 6 dosing facil-
ity.
▶ Guide the tube through the orifice of the coarse sieve of the KaVo OXYGENAL 6
bottle.
▶ Screw the KaVo OXYGENAL 6 dosing facility tightly to the KaVo OXYGENAL 6
bottle.
▶ Rotate the orifice in the lid to a filling level of 1 litres.
ð Lid snaps-in in the filling position.
▶ Place the KaVo OXYGENAL 6 bottle on a level surface.
▶ Squeeze the KaVo OXYGENAL 6 bottle until the germ reduction liquid rises above
the red marker.
ð In response to over-filling, the excess quantity above the tick mark is aspirated
automatically to ensure exact dosing.
▶ Remove and empty the pressurised water bottle.
▶ Fill the pressurised water bottle with KaVo OXYGENAL 6. Make sure that the
spout of the KaVo OXYGENAL 6 dosing facility (nose) is situated right above the
opening of the pressurised water bottle.
▶ Then fill-up the pressurised water bottle with tap water, and reinsert it.
63 / 74
To Next Page
Loading...