B-2 SCAN EXAM
B. Installation and setup
B.1.3 Other devices
DO NOT connect any other devices to the unit
or the PC(s) connected to the unit that are:
- not part of the supplied system
- not supplied by the manufacturer of the
unit
- not recommended by the manufacturer of
the unit.
B.2 Connecting the unit to a PC / LAN
The procedure for connecting the unit to
a single PC or several PCs in a local area
network (LAN) is exactly the same except
that every PC in the LAN needs to be given a
unique ID number.
B.2.1 Automatic connection (preferred)
Make sure that the imaging plate unit is
connected to the network and powered.
The software driver can automatically detect
all devices that are in the LAN and the power
is ON.
The detection starts automatically at the
software application install.
1. If the software is already installed or
fails to start the Add Device Wizard
automatically, launch it from the Image
Capturing Window.
2. From the Image capture window press
Settings.
To Next Page
Loading...
Need help?
General
