6 1
Name: Basis
KEB COMBIVERT F5-G / B
14
24.06.02
Functional Description
© KEB Antriebstechnik, 2002
All rights reserved
Chapter Section Page Date
Operating and Appliance Data
Adr.
min max
default
0223h
ru.35 Analog output 2 / display before amplification
0.1
%
-
400-400
This parameter shows the value of the analog signal ANOUT2 in percent before passing the characteristic amplifier (also
see Chapt. 6.2 „Analog outputs“).
Adr.
min max
default
0224h
ru.36 Analog ouptut 2 / display after amplification
0.1
%
-
1000
This parameter shows the value of the signal given out on analog output ANOUT2 (terminal X2A.6) in percent. The value
of 0...±100 % corresponds to an output signal of 0...±10 V (also see Chapt. 6.2 „Analog outputs“).
Adr.
min max
default
2025h
ru.37 Motorpoti - actual value
0.01
%
0
100-100
The motorpoti-function in the KEB COMBIVERT imitates a mechanical, motor operated potentiometer. The control
occurs via 2 programmable inputs („poti up“ and „poti down“). The display is limited by oP.53/54. The adjustment of the
motorpoti is done with the parameters oP.50...oP.59 (also see Chapt. 6.9.3 „Motorpoti“). By way of the bus the motorpoti
can be set to any chosen value between -100...100%. In addition to the inputs the motorpoti can be operated with the
keys „UP“ and „DOWN“. Then the rate of change is not constant.
Adr.
min max
default
0221h
ru.33 Analog output 1 / display before amplification
0.1
%
-
400-400
This parameter shows the value of the analog signal ANOUT1 in percent before passing the characteristic amplifier
(also see Chapt. 6.2. „Analog outputs“).
Adr.
min max
default
0222h
ru.34 Analog output 1 / display after amplification
0.1
%
-
100-100
This parameter shows the value of the signal given out on analog output ANOUT1 (terminal X2A.5) in percent. A value
of 0...±100 % correponds to an output signal of 0...±10 V (also see Chapt. 6.2 „Analog outputs“).
To Next Page
Loading...
