KEB COMBIVERT F5 MULTI

6
81
KEB COMBIVERT F5
Name: Basis
05.05.04
Functional Description
Chapter
Section
Page
Date
© KEB Antriebstechnik, 2002
All rights reserved
1. Introduction
2. Summary
3. Hardware
4. Operation
5. Parameter
6. Functions
7. Start-up
8. Special Operation
9. Error Assistance
10. Project Planning
11. Networks
12. Annex
6.1 Operating and Applicance
Date
6.2 Analog In- and Outputs
6.3 Digital In- and Outputs
6.4 Set Value and Ramp
Adjustment
6.5 Voltage-/Frequency
Characteristic (U/f)
Adjustment
6.6 Motor Data Adjustment
6.7 Protective Functions
6.8 Parameter Sets
6.9 Special Functions
6.10 Encoder Interface
6.11 SMM, Posi, Synchron, CTM
6.12 Technology Control
6.13 CP-Parameter Definition
6.8.1 Not programmable
Parameters ............................. 3
6.8.2 Security-Parameters ............... 3
6.8.3 System-Parameters ................ 3
6.8.4 Indirect and Direct
Set Addressing....................... 3
6.8.5 Copying of Parameter Sets via
Keyboard ................................ 4
6.8.6 Copying of Parameter Sets via
Bus ......................................... 4
6.8.7 Parameter Set Selection ........ 5
6.8.8 Locking of Parameter Sets ..... 8
6.8.9 Parameter Set ON and OFF
Delay ...................................... 8
6.8.10 Used Parameters .................... 9