KEB COMBIVERT F5 MULTI

4
CP - Parameter Operation
4
33
KEB COMBIVERT F5-M / S
Name: Basis
17.05.04
Section PageDate
© KEB Antriebstechnik, 2003
All Rights reserved
Chapter
4.3.1 Operation in
CP-Mode
4.3 CP-Parameter
The Customer-Parameters (CP) are a special group of parameter. With the exception
of CP.0 (Password input), they can be defined by the user. The following Parameters
are preset at delivery.
Advantages from it: - operator-friendly for the customer
- critical parameters are protected against maloperation
- low documentation cost for the machine builder
FUNCT
SPEED
▲
START
▼
STOP
▲
START
▼
STOP
Adjustment of
parameter number
Adjustment of
parameter value
Compared to the Application-Mode the operation in the CP-Mode is easier because
parameter set selection and parameter group selection are unnecessary.