KEB COMBIVERT F5 Servo

Functional Description
1. Introduction
2. Summary
3. Hardware
4. Operation
5. Parameter
6. Functions
7. Start-up
8. Special Operation
9. Error Assistance
10. Project Planning
11. Networks
12. Annex
6.1 Operating and Applicance
Date
6.2 Analog In- and Outputs
6.3 Digital In- and Outputs
6.4 Set Value and Ramp
Adjustment
6.5 Voltage-/Frequency
Characteristic (U/f)
Adjustment
6.6 Motor Data Adjustment
6.7 Protective Functions
6.8 Parameter Sets
6.9 Special Functions
6.10 Encoder Interface
6.11 SMM, Posi, Synchron
6.12 Technology Control
6.13 CP-Parameter Definition
6
21
KEB COMBIVERT F5
Name: Basis Chapter Section PageDate
© KEB Antriebstechnik, 2002
All rights reserved
04.05.04
6.2.1 Summary Description
Analog Inputs ......................... 3
6.2.2 Interface Selection.................. 4
6.2.3 Interference Suppression Filter 5
6.2.4 Save mode ............................. 5
6.2.5 Input selection ........................ 5
6.2.6 Zero point hysteresis .............. 6
6.2.7 Amplifier of the Input
Characteristic ......................... 7
6.2.8 Lower and Upper Limit ............ 8
6.2.9 Selection Set Point-/
Auxiliary Input ........................ 9
6.2.10 Summary Description
Analog Outputs..................... 10
6.2.11 Output Signals ...................... 11
6.2.12 Analog Output / Functions .... 11
6.2.13 Analog Output / Display ........ 11
6.2.14 Amplifier of the Output
Characteristic ....................... 11
6.2.15 Period ANOUT3 .................... 13
6.2.16 Digital Settings ..................... 13
6.2.17 Used Parameters .................. 14