KEB COMBIVERT F5 Servo

6
11 1
KEB COMBIVERT F5-M / S
Name: Basis
06.05.04
Section PageDate
© KEB Antriebstechnik, 2002
All Rights reserved
Chapter
Functional Desription
1. Introduction
2. Summary
3. Hardware
4. Operation
5. Parameter
6. Functions
7. Start-up
8. Special Operation
9. Error Assistance
10. Project Planning
11. Networks
12. Annex
Positioning and Synchronous Control
6.1 Operating and Unit Datas
6.2 Analog In- and Outputs
6.3 Digital In- and Outputs
6.4 Setpoint- and Ramp
Adjustment
6.5 Voltage-/Frequency
Characteristic Adjustment
6.6 Motor Data and Controller
6.7 Protective Functions
6.8 Parameter Sets
6.9 Special Functions
6.10 Encoder Interface
6.11 Posi-/ Synchronous Control
and Contouring mode
6.12 Technology Controller
6.13 CP-Parameter Definition
6.11.1 Synchronous Control ...............3
6.11.2 Slave Correction .....................4
6.11.3 Position Controller ...................5
6.11.4 Position Display ......................5
6.11.5 Reference Point Approach.......6
6.11.6 Reference Point Approach
Examples ................................7
6.11.7 Posi Control ..........................12
6.11.8 Position sensing....................17
6.11.9 Teach mode ..........................18
6.11.10 Contouring mode (CTM) ........19
6.11.11 Used Parameters ..................20