KEB COMBIVERT F5 Servo

Functional Desription
1. Introduction
2. Summary
3. Hardware
4. Operation
5. Parameter
6. Functions
7. Start-up
8. Special Operation
9. Error Assistance
10. Project Planning
11. Networks
12. Annex
Operating and Unit Data
6
11
KEB COMBIVERT F5-M / S
Name: Basis
12.05.04
Section PageDate
© KEB Antriebstechnik, 2002
All Rights reserved
Chapter
6.1 Operating and Unit Data
6.2 Analog In- and Outputs
6.3 Digital In- and Outputs
6.4 Setpoint- and Ramp
Adjustment
6.5 Voltage-/Frequency
Characteristic Adjustment
6.6 Motor Data and Controller
6.7 Protective Functions
6.8 Parameter Sets
6.9 Special Functions
6.10 Encoder Interface
6.11 Posi-, Synchronous Control
and Contouring Mode
6.12 Technology Controller
6.13 CP-Parameter Definition
6.1.1 Summary of ru-Parameter ....... 3
6.1.2 Summary of In-Parameter ....... 4
6.1.3 Summary of Sy-Parameter ..... 4
6.1.4 Explanation to Parameter
Description ............................. 5
6.1.5 Description of ru-Parameter .... 6
6.1.6 Description of In-Parameter .. 21
6.1.7 Description of Sy-Parameter . 25