KEB COMBIVERT F5 Servo

6
41
KEB COMBIVERT F5-M / S
Name: Basis
12.05.04
Section PageDate
© KEB Antriebstechnik, 2002
All Rights reserved
Chapter
Functional Desription
1. Introduction
2. Summary
3. Hardware
4. Operation
5. Parameter
6. Functions
7. Start-up
8. Special Operation
9. Error Assistance
10. Project Planning
11. Networks
12. Annex
Setpoint- and Ramp Adjustment
6.1 Operating and Unit Data
6.2 Analog In- and Outputs
6.3 Digital In- and Outputs
6.4 Setpoint- and Ramp
Adjustment
6.5 Voltage-/Frequency
Characteristic Adjustment
6.6 Motor Data and Controller
6.7 Protective Functions
6.8 Parameter Sets
6.9 Special Functions
6.10 Encoder Interface
6.11 Positioning and
Synchronous Control
6.12 Technology Controller
6.13 CP-Parameter Definition
6.4.1 Brief Description ..................... 3
6.4.2 Reference source ................... 4
6.4.3 Rotation source ...................... 6
6.4.4 Fixed values ........................... 9
6.4.5 Setpoint Limits ..................... 11
6.4.6 Setpoint Calculation .............. 12
6.4.7 Ramp Generator ................... 13
6.4.8 Limiter
6.4.9 Ramp with constant Time ..... 15
6.4.10 Used Parameters .................. 18