KEB COMBIVERT F5 Servo User Manual

3
4
23
KEB COMBIVERT F5
Name: Basis
04.05.04
4
Password Structure
© KEB Antriebstechnik, 2002
All Rights reserved
Operation
Section PageDate Chapter
4.2 Password
Structure
The KEB COMBIVERT is provided with extensive password protection. The diffe-
rent passwords are used to
- change the operating mode
- set a write protection
- activate the Service-Mode
- switch to the Drive-Mode
Depending on the actual operating mode the password can be entered in following
parameters
when the CP-Mode is active
when the applicatioan mode is active
The parameter value of the above parameters shows the actual password level.
Following indications are possible:
CP - read only
CP - on
CP - Service
Application
Drive-Mode
4.2.1 Password Levels
Only the Customer-parameter
group is visible, exept for CP.0 all
parameters are in the read-only
status (see chapter 4.3).
Only the Customer-parameter
group is visible. All parameters can
be changed.
Like CP-on, but the parameter
identification is indicated according
to the original parameter (see
chapter 4.3).
All application parameters are vi-
sible and can be changed. The CP-
parameters are not visible.
The Drive-Mode is a special
operating mode, here the unit can
be put into operation via the
operator (see chapter 4.4).

KEB COMBIVERT F5 Servo Specifications

General

Brand	KEB
Model	COMBIVERT F5 Servo
Category	DC Drives
Language	English