KEB F6 Series User Manual

12
PRODUCT DESCRIPTION
2 Product description
The device series F6 is a series of single axis drive controllers. These devices are
equipped with a diagnostic interface (description see F6 control boards). The F6 opera-
tors can be connected to this interface.
These operators can perform the following tasks:
• Providing a user surface (keyboard and display)
• Providing a diagnostic interface (USB or Ethernet)
The operators can not perform the following tasks:
• Providing of interfaces for permanent installation (eldbuses / IO / etc.)
Information about the F6-A control boards can be found here.
www.keb.de/leadmin/media/Manuals/dr/ma_dr_f6-cu-a-inst-20118593_en.pdf
Information about the F6-K control boards can be found here.
www.keb.de/leadmin/media/Manuals/dr/ma_dr_f6-cu-k-inst-20144795_en.pdf
Information about the F6-P control boards can be found here.
www.keb.de/leadmin/media/Manuals/dr/ma_dr_f6-cu-p-inst-20182705_en.pdf
2.1 Specied Application
The F6 serves exclusively for the control and regulation of three-phase motors. It is in-
tended for the installation into electrical systems or machines.
Technical data and information for connection conditions shall be taken from the name-
plate and from the instructions for use and must be strictly observed.
The semiconductors and components used in KEB products are developed and de-
signed for use in industrial products.
Restriction
The product is not permitted to be used in vital life-sustaining applications, i.e. medical,
without the expressed written consent of KEB Automation KG or KEB America Inc. gen-
eral management.

KEB F6 Series Specifications

General

Communication Interfaces	RS-485, Modbus RTU, CANopen
Protection	Overcurrent, overvoltage, undervoltage, short circuit
Operating Temperature	-10°C to +40°C
Humidity	Up to 95% relative humidity, non-condensing
Control Modes	sensorless vector control (ASCL), closed-loop vector control (encoder feedback)