KEB F6 Series

6.8 Parameter saving
Inverter parameter
Operator parameter
Parameter saving
Up/Download
Work list
File operations
FTP mode
Enter test mode
ENTER opens the submenu for parameter saving.
Parameter saving (Upload) = F3
All inverter and operator parameters are read and saved in the
flash memory. Every new upload process overwrites the pre-
saved parameter lists.
Write parameter (Download) = F4
A download is not possible without saved inverter parameters. If
inverter parameters are not saved, an error message will occur.
Figure 18: Parameter saving
6.9 Upload/download of parameters
Inverter parameter
Operator parameter
Parameter saving
Up/Download
Work list
File operations
FTP mode
Enter test mode
ENTER opens the submenu for uploading and downloading.
Generate dw5 le (CList) = F2
Generate new dw5 le of the current CongID to use the Up-
load/Download functions.
Parameter saving (Upload) = F3
A download list is loaded from the current drive controller and
stored under new name.
Write parameter (Download) = F4
An existing download list is stored in the drive controller.
Parameter lists, created with COMBIVIS in .dw5 format can be
transmitted via ftp to the operator.
Figure 19: Upload/download of parameters
37
NAVIGATION